#00Tip

• For Jewelry or 26-28 gauge sheet metal.
• Use anytime a VERY SMALL Flame is needed like for jewelry work or small prototype work or models.
• Identify by knurl pattern.

$20.00 each + applicable tax (NC/SC only)

#1/2 Tip

• For Automotive Sheet metal (18-22) gauge
• Also works well on .030 chromemoly and EMT (conduit) Our most popular option
• Identify by small single groove (smaller than #1)

$20.00 each + applicable tax (NC/SC only)

#1.5Tip

• NEW ACCESSORY
• This tip is for 1/8-3/16 welding
• If the #1 tip is too small or the #2 tip is too large this one will be just right.

$20.00 each + applicable tax (NC/SC only)

• For Heavy Duty Welding like Engine Blocks & Cylinder Heads
• For thick aluminum or cast iron (3/8" to 1'')
• Identify by parallel ribs.

$20.00 each + applicable tax (NC/SC only)

• Air-Acetylene tip uses only acetylene, NO Oxygen
• Used for Body Solder (Lead work) on body panels and soldering of copper pipe.
• Works like a Turbo or propane torch.
• Works well for thawing frozen water pipes or general purpose heating when a lower temperature very soft bushy flame is needed.
   

$35.00 each

 6"Straight Welding tip Extension

• For confined areas such as ports in cylinder heads or to move your hand back from the heat when welding heavy materials

$25.00 each + applicable tax (NC/SC only)

• For Overhead Welding such as exhaust , roll cages ,aircraft frames and in HVAC & Plumbing applications
• About "6" long with 135 degree bend

$25.00 each + applicable tax (NC/SC only)

Includes the following welding tips and accessories:

• 00 Tip
• 1.5 Tip
• 2.5 Tip
• Curved Extension
• Straight Extension
• Air-acetylene Tip
  
  (a total value of $145.00)

$99.00 each + applicable tax (NC/SC only)

Rosebud Heating Tip   

For heating large areas and bending thick metal.

For all Dillon, Henrob, Cobra or DHC 2000 torches,

New Rosebud Heating Tip on Henrob torch.

 

$105.00 each + applicable tax (NC/SC only)

• Light weight 3/16 in. 50% lighter than standard 1/4 in. hose
• Twin welding hose grade (R) made in USA  
• Standard "B" fittings

12.5 ft length  $20.00 each + applicable tax (NC/SC only)

25 ft length     $30.00 each + applicable tax (NC/SC only)

• Comes with one each; acetylene male, acetylene female, oxygen male, oxygen female 
• One set is required for each torch to be connected

Torch to Hose -1 set       $65.00 each + applicable tax (NC/SC only)

Torch to Hose - 2 sets     $125.00 each + applicable tax (NC/SC only)

Hose to Hose -1 set       $65.00 each + applicable tax (NC/SC only)

Hose to Hose - 2 sets     $125.00 each + applicable tax (NC/SC only)

Regulators to Hose -1 set       $65.00 each + applicable tax (NC/SC only)

Regulators to Hose - 2 sets     $125.00 each + applicable tax (NC/SC only)