Basic kit includes the following:

• case (These are the new cases that now hold all accessories)
• torch
• 5 Welding tips  (0,0.5,1,2,3)
• sheet metal and plate cutting attachments
• cutting tip
• guide wheels
• tip cleaners
• wrench and manual
• Custom Instructional DVD *
  Our instructional DVD is a very helpful tool to help you learn the
  capabilities and to demonstrate cutting and welding methods.
  Much of this DVD can be seen in our "streaming video library"
• Jim's Suggestions *
  This is a supplement to the manual with listings of the required
  welding rods, fluxes etc. and helpful operational tips and suggestions.
  * NOTE : Both DVD and supplement are exclusive to J & S.
• Free technical support 8am-7pm EST Mon-Sat.

regular price - $599

DHC 2000 Basic
Torch Kit

Instructional (DVD)
and Jim's Suggestions

Cobra single stage low pressure regulators

Both single stage regulators, one each, Oxy/Acetylene

 Custom made for the DHC 2000 torch, these make it simpler to set the pressure to the 4 psi required for our torch.

• Oxygen single stage
  Regulator pressure range 2-25 psi (gauge reads 4-60 psi)
  with CGA-540(standard) tank connector and "B" hose fitting.

regular  price $140

• Acetylene single stage
  POL (standard) tank connector and "B" hose fitting.

regular  price $140

• 25 ft Hose
  USA made lightweight 3/16 in X 12.5 ft hose

regular  price $30

Total retail value - $679
(FREE SHIPPING Contiguous US, UPS addresses only)

Call to substitute instructional
VHS tape for DVD